Slicer Discord
Voice Assistant Case – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Voice Assistant Case

31 Downloads
19 Likes
17 Makes
Zum Modell
This is a case for a Raspberry Zero which is equipped with a ReSpeaker2 Hat and a loudspeaker.This device acts as a Home Assistant Voice satellite / Rhasspy satellite.The lid is covered with speaker fabric and has a button that presses the on the ReSpeaker2.Due to the recesses on the back it is possible to connect a USB dongle and an external loudspeaker in addition to the power cable.Simply apply a little glue to the lid and stick the fabric on. Then place the lid on the housing and, if necessary, use a thin screwdriver to push the excess fabric into the gap.The following speakers are provided:Large Hole spacing 63x24mm - Case_LSmall Hole spacing 36mm - Case_SDeutsche Version:Hierbei handelt es sich um ein Gehäuse für einen Raspberry Zero welcher mit einem ReSpeaker2 Hat und einem Lautsprecher ausgestattet ist.Dieses Gerät dient als Home Assistant Voice Satellite / Rhasspy - Satellite.Der Deckel ist mit Lautsprecherstoff bezogen und besitzt einen Knopf welcher den auf dem ReSpeaker2 d
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
63 mm (Klein)
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

4 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen