Slicer Discord
Voron 0.1 pi camera bed level mount – 3D-printbaar model van MakerWorld MakerWorld
3D Printer Accessories

Voron 0.1 pi camera bed level mount

0 Downloads
0 Likes
0 Makes
Model downloaden
Simple camera mount to a small usb pi-camera. I've fitted this with an old pi-camera I had laying around, which had a microphone (hence the extra hole) - I note most pi-camera's don't need this hole. I stripped the usb lead of outer cover for the section that is placed inside the aluminium extrusion to aid fitting. The camera placement is just high enough to see the top of the bed when printing the 1st layer. Note this can be fitted with either one or two screws (depending how many nuts are pre-loaded - by removing the 2nd left hand support. You'll see from the photos extended to support from both sides as I was worried it may start to drop over time with only one side supported.
Categorie
3D Printer Accessories
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie