Voron 0.1 Temperature Display

Digital temperature display mount with temp sensor holder, mounted level with hotend.
Good for printing ABS.

The front skirt of the Voron 0.1 has been modified to hold a digital display so you can clearly see the temperature inside the enclosure.

The cable to the sensor is routed under the printer, up inside the back of the enclosure and attached with an M3 bolt and nut.

The temperature sensor has a mount which you attach at the same level as the hotend. This will give an accurate indication of the enclosure temperature for the first layers of the print. Important for printing ABS, Nylon and other difficult plastics.

Full instructions can been seen on YouTube


Digital thermometer from Aliexpress https://www.aliexpress.com/item/4000920348926.html

STLs for the skirt, display holder and sensor holder are below.

Ideally print the sensor holder in ABS as its inside the enclosure where it'll be toasty.

0.2mm layer height, no supports.