Voron 2.4 BLtouch mount

This is a new mount for the Voron wich replaces the standard probe PL-08N2 with a BLtouch.

The BLtouch will fit in the same space as the probe PL-08N2 and be held in place by the beltclips.

Print the two parts in ABS with 0.2mm layer, 4 outlines and 30% infill.

The standard probe PL-08N2 have a max operating temperature of 70 degree Celcius and will melt eventually when printing ABS in a closed chamber.
The BLtouch have a higher operating temperature and is more accurate.

To wire up the BLtouch find any documentation for your specific electronics board.
I have included a picture on how to wire it up with the Fysetc Spider Board.

It's quite easy to change the firmware to use the BLtouch.
In the printer.cfg file uncomment all probe settings and uncomment the BLtouch settings.

#####################################################################
# Probe
#####################################################################

#[probe]
## This probe is not used for Z