Thingiverse
Voron 2.4 Camera Mount
par tron3dfu
36
Téléchargements
15
Likes
0
Makes
This is a simple camera mount intended to be mounted at the back of a Voron 2.4 printer. With a wide-angle lens camera (this is the one I used: https://www.amazon.com/gp/product/B08F2FN51Z/), you should be able to see the entire inside of a 350mm ^ 3 Voron 2.4 printer (see the last photo).
I tried various spots in the printer and found the back center underneath the lowest point of the gantry to be the most optimal. It is out of the way and still provides a full view and is optimized for the area closest to the bed which is where most prints occur.
BOM:
M2.5 x 10 mm screws (2)
M2.5 nuts (2)
Wide-angle USB camera (1)
M3 x 8 mm screw (1)
M3 spring nut for a 2020 extrusion (1)
I tried various spots in the printer and found the back center underneath the lowest point of the gantry to be the most optimal. It is out of the way and still provides a full view and is optimized for the area closest to the bed which is where most prints occur.
BOM:
M2.5 x 10 mm screws (2)
M2.5 nuts (2)
Wide-angle USB camera (1)
M3 x 8 mm screw (1)
M3 spring nut for a 2020 extrusion (1)
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !