Voron Stealthburner for Hypercube Evolution Rail System (HevoRS)

After installing the Afterburner as a direct extruder on the HevoRS for over 3 years, it was time for something new.

I wanted to install the stealth burner without making any major changes to the “Voron parts”. The result is this HevoRS belt block with the option of mounting the Voron Carriage. However, for stability I did make two holes in the carriage.

The follow screws are needed:
block: 5x m3x45
carrier: 2x m3x8 + 2x m3x10
belt tension: 2x m3x16 - 24