Voron V0 LED rail

This mod is a LED strip holder for the Voron V0 3D-printer. It should hold any 10mm wide LED strip, but I used it with RGB WS2812 Individually Addressable LEDs. I used a 30 LED/meter (low density) strip to fit 5 LED per side. To make the wiring easier, I put them in parallel (see the wiring diagram in the files).

The LED are fully controllable by the firmware. I included a sample configuration Klipper file for the SKR mini E3 V2.0. I recommend making the LED macros easily accessible by using the Octoprint "Sidebar Macros" plugin (eg: On Full brightness, Off, On dim, ...).

Parts required per rail (double for each side; quadruple for both sides):
* 2 M3×8 BHCS screw
* 2 M3 nuts

Note: M3 nuts must be inserted on the inner side of the top extrusion. Fortunately, this can be done with minimal disassembly!

Other mods on my Voron V0:
* VORON V0.1 CR10 Hotend (Mini Afterburner mod) by me (https://www.thingiverse.com/thing:5239499)
* The Ultimate Spool Holder by filamentry (http