Voron2.4 StealthBurner TOOL BRD

中文：
设计使用HDMI线缆24v 50W发热器 以500mm/s空驶，120mm/s打印速度，80mm/s外壁速度连续密封ABS打印了500小时无故障；
HDMI为原创设计，6pin对插参考hartk的设计思路，风扇分线板集成5~40V转5V降压电路，可以直接使用WS2812灯珠，分线板可以直接共用树莓派3b板型的螺丝孔挂在板尾；
提供5050灯珠免PCB打印件，可以直接打印粘接灯珠后焊线
需要更换原SB头的一颗电机固定M3*30杯头螺丝为35长度，其他五金及打印件不变
此设计遵循CC-SA，最终解释权归Dsfrick所有

EN:
Designed to use the HDMI cable and 24V 50W heater free drive speed at 500mm/s, 120mm/s printing speed, 80mm/s outer wall speed to continuously seal ABS printing for 500 hours without faults;

Use HDMI cable for sb head is an original design. The 6pin pair refers to hartk's design idea. The fan divider board is integrated with 5~40V to 5V voltage-reducing circuit. WS2812 neorgb led can be used directly. The ender divider boards can share the screw holes of raspberry pi 3B tail.

Provides 5050 led PCB-free printouts for direct printing of bonded beads back weld wires

A screw for motor that needs to replace the original SB head fixes the M3*30 cup head screw to 35 lengths, other hardware and printers remain