Voronoi Dragonfly

The Voronoi patterns flash contest immediately made me think of insect wings, and so this dragonfly was born. This snap-fit model features posable ball-jointed wings and an elegant display stand.   Print Settings Print files are divided into Body, Wings, and Stand. Just print one of each file. If you’ve printed any of my other jointed figures, you should be familiar with the recommended settings. MaterialPLA*, PETG, ABS, or ASALayer height0.15mm (first layer 0.2mm)Infill10-20% rectilinearSupportsNone *PLA is not recommended for the Body, because the sockets of the wing joints can break during assembly or become loose over time. However, it will work if it's all you have. If you have issues with bed adhesion, try lowering your first layer speed and/or adding a brim.   Assembly As always, assembly requires no glue or screws, just patience. :) Insert the Abdomen (tail) through the Thorax and into the Head. Snap the Wings into the sockets on the Thorax. The side that was touching the build plate should be facing up. Insert the Arm of the display stand through the Base (from below) and then into the Thorax. Pose the wings however you like!   This design is now under a CC BY 4.0 license. This means that you are free to share these files however you like, including selling prints, provided that you give proper attribution. You can give proper attribution by including this notice on your product page: Voronoi Dragonfly © 2024 by Lucky 13 Toys is licensed under CC BY 4.0 Please help me build my identity as a creator by referring to this design by its original name. Don't pass off my work as your own product. If this free model brought you joy (or profit), consider making a donation: PayPal | Stripe | Buy Me a Coffee