Voronoi Easter bunny fixed with opening

Update V5: I finally managed to make my own bunny. Based on the Standard bunny in meshmixer. I've straightened the ears so it prints easier, created the mesh and implemented the same lock as in V3. If printed at full size the inner diameter of the opening is about 30 mm, so you can put some nice things in ;-)
Also this bunny should be possible to size down up to aprx. 50%, at least on my printer.

Advantage in my eyes:
- prints a bit faster
- thicker structure allows sizing down
- large opening for goodies

Any comments or Pictures of makes would be greatly appreciated.

Update 4: Another additional model more suitable for sizing down. I'm printing one at 50% atm. Again the inner lock part is alredy sized down and there is a complete model as well.
This bunny is based on the Tron bunny by gpvillamil and was editied in Meshmixer and Tinkercad. Same locking mechanism as the other bunnies.


Update V3: Additional model with larger opening for bigger goodies. With my printer