Thingiverse
Vortex Vibe Keyboard Wallmount
3
Downloads
4
Likes
0
Makes
This is a Wallmount for a Vortex Vibe. I've got two of them, since this seems to be quite the only Boutique-Keyboard with european layout and numblock.
It might be fitting for other keyboards too, which bases are about 12mm thickness and can handle a 1.5mm inset.
### The printing orientation:
The part is printed with the longer clamp-side downwards. The wall with the holes faced vertically up. No Supports are needed in this orientation. 20% Gyroid suppport was used with 2x0.8mm Wall thickness.
It might be fitting for other keyboards too, which bases are about 12mm thickness and can handle a 1.5mm inset.
### The printing orientation:
The part is printed with the longer clamp-side downwards. The wall with the holes faced vertically up. No Supports are needed in this orientation. 20% Gyroid suppport was used with 2x0.8mm Wall thickness.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
