Thingiverse
VS4-10 Phoenix shock collars
von Guden79
6
Downloads
5
Likes
0
Makes
If there are problems with spring collars from Vanquish Products S4-10 Phoenix, i hade to made my own ones.
Since the kit is still on the way to me, I was only able to measure with GTS dampers from the TRX4, but since the spring caps from the GTR dampers also fit on the Phoenix, it should work.
When the kit arrives, I will check whether it fits 100% on the Phoenix.
Printed with 0,1mm layerhight and 100% infill.
Since the kit is still on the way to me, I was only able to measure with GTS dampers from the TRX4, but since the spring caps from the GTR dampers also fit on the Phoenix, it should work.
When the kit arrives, I will check whether it fits 100% on the Phoenix.
Printed with 0,1mm layerhight and 100% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!