Vsett 10 - fender extender

This is a redesign of https://www.prusaprinters.org/prints/119639-vsett-10-fender-extension?fbclid=IwAR3jNEyIEAT6MlIpeL8-iO8wdN4ptEB0XZjm6tJ073BZKfArk4bkt-zr8zU .
The picture of a green and orange version you should look at it as the green is original
and the orange is my change to the design that allows more room
for the tire .
It can be used both front and rear .
It fits the HOTA tire perfectly .
I do recommend printing in TPU 98a sore hardness with 3 perimeters
and 30% infill ,this allows the fender extender to move if the
dampers bottom out