Thingiverse
vsr-10 TDC
por adas1223
19
Descargas
11
Likes
0
Makes
simple tdc (top dead center) mod for the vsr10 / bar10 platform with regular 30mm barrel, and stock vsr hop up unit.
it comes with a jig to drill the top hole for an m3 screw 90 degrees. (obviously use a slightly larger diameter drill bit)
the stock vsr hop up unit should be disassembled as the adjuster arm and screws will not be needed anymore. the m3 screw will press down on the original plastic hop arm.
the second part of the print is the actual TDC housing. An m3 16mm screw will self thread into the 2.65mm hole and creates a nyloc type hold so it shouldnt back out.
the housing itself should be super glued well onto the barrel. slight sanding for prep near the hole should be enough to keep the housing in place even with pressure from adjustment.
it comes with a jig to drill the top hole for an m3 screw 90 degrees. (obviously use a slightly larger diameter drill bit)
the stock vsr hop up unit should be disassembled as the adjuster arm and screws will not be needed anymore. the m3 screw will press down on the original plastic hop arm.
the second part of the print is the actual TDC housing. An m3 16mm screw will self thread into the 2.65mm hole and creates a nyloc type hold so it shouldnt back out.
the housing itself should be super glued well onto the barrel. slight sanding for prep near the hole should be enough to keep the housing in place even with pressure from adjustment.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
