Thingiverse
Vufine Dock Mount
door fiveseven808
17
Downloads
9
Likes
0
Makes
I don't have very flexible filament, but I wanted to print this. I managed to modify it smaller so I don't need to print the "sticky" parts and glue in a 1mm thick magnet I had found in some "nice" packaging that used magnets. I didn't realize that the vufine has 2 magnets in it for stability reasons, so this mount may need to be redesigned.
I printed this with Ninjatek Armadillo since that's the only TPU I have. The strap is a bit stiff, may need to thin it out a bit... but otherwise, it holds onto my Oakley's Five's Squared, which was the main goal.
I like this mount way better than the ball joint one. That one is terrible, I just need to find a way to keep my vufine from sliding down with the current... might redesign it again.
Need to find more small magnets.
I printed this with Ninjatek Armadillo since that's the only TPU I have. The strap is a bit stiff, may need to thin it out a bit... but otherwise, it holds onto my Oakley's Five's Squared, which was the main goal.
I like this mount way better than the ball joint one. That one is terrible, I just need to find a way to keep my vufine from sliding down with the current... might redesign it again.
Need to find more small magnets.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!