VW T3 short / quick shift

VW T3 Short shift spacer designed to reduce the angle that the shaft travels by 25%Use PETG or ABS.0.4 nozzle, 0.2 layer height(no forces applied to the spacer when installed, but people manage to destroy anything so use 20% infill and upwards.)To finish installation you will need 2x 2cm stub/nut extensions (check pictures) that screw on your existing studs or nuts under shifter kit and then after placing the shifter spacer secure it with nuts/screws on the two extensions.Plenty of install instructions online but in short... remove shifter knob, slide up rubber boot, mark and drill with a 4mm drill bit, 2mm deep hole 1.3cm above the locking collar (ring above the spring). Undo the locking collar and slide the whole shifter/bushing assembly off the shifter lever. Install 2x stub/nut extensions, place spacer, slide the assembly back onto the gear lever, bolt it back into it’s original position and then secure the locking collar using newly drilled indent.Happy shifting!