Thingiverse
VZBOT BROR IKEA HACK
by SOLESHOE
2
Downloads
0
Likes
0
Makes
3 STL files allowing to enclose and attach a vzbot330 in a ikea bror system shelf
I am still working on enclosure itself. bror 3d model available on internet do not have accurate dimensions so far, so i have to make precise measurement on my own.
Back plate enclosure is particulary difficult because the back of the printer gets partially outside of the shelf.
I use a 65x55 cm bror shelf, attached in a L configuration to a 65x30 cm shelf.
this way the 65x55 is set 10cm away from the wall, which is enough room for the vzbot electronic and cooling system.
I am still working on enclosure itself. bror 3d model available on internet do not have accurate dimensions so far, so i have to make precise measurement on my own.
Back plate enclosure is particulary difficult because the back of the printer gets partially outside of the shelf.
I use a 65x55 cm bror shelf, attached in a L configuration to a 65x30 cm shelf.
this way the 65x55 is set 10cm away from the wall, which is enough room for the vzbot electronic and cooling system.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!