Thingiverse
Wacaco Minipresso pump replacement
por Kaptan_GAK
4
Descargas
3
Likes
0
Makes
The pump is held in with 2 tiny clips that can break oh so easily.
Print with heat resistant filament (I used ABS) then to strengthen I washed with acetone as it is very thin.
Update Split option included:
If you are adventitious and dismantle the MiniPressio (remove 4 screws from coffee side under rubber) use the split option as that takes the pressure of trying to get the pins in without damaging them).
Good luck.
Print with heat resistant filament (I used ABS) then to strengthen I washed with acetone as it is very thin.
Update Split option included:
If you are adventitious and dismantle the MiniPressio (remove 4 screws from coffee side under rubber) use the split option as that takes the pressure of trying to get the pins in without damaging them).
Good luck.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!