Wahl "0.5" guard

This guard fits Wahl brand clippers sold at Costco. This guard is slightly closer than a #1. I like to call it a #1/2 but i do not actually know. I printed this in grey hatchbox pla.

Printing:
I printed it on it's small edge to maintain strength where the clippers need it the most. My printer also likes to steal ~0.5mm in the z due to the heated glass bed so printing it on the side kept the blades from being weakened.

I printed it at ~50mm/s, 0.1 layer size, 15% infill, 15% support and 1.2mm walls.

Printing on edge requires support.

Design:
I did the fit of the clippers face first. I then drew a master blade in the plane of the guard edge to meet my length requirements and to fit the clippers. This was a connected poly-line that I extruded to form my first blade right on the edge of the clippers. I multiplied and transformed the blade across the tip of the guard and added support to the blades on the end for extra strength and to hold the clippers better. I then filleted