Walking Bucket

This is my Walking Bucket for the Maker's Supply Wind-Up Mechanism Kit MD001.The lid and the eyes are optional but highly recommended. Print preparation:Make sure that your print bed is clean and grease-free and use a quality brand and dry filament. If you are having bed adhesion issues you can always try the new Bambu SuperTack plate (do not forget to change the plate in slicer). Print settings:Use the 0.2mm standard settings for everything. The bucket needs support. To optimize the adhesion use a brim for the handle and the bucket.For the lid and the eyes you can switch on the smooth adaptive layer setting. This will result in extra smooth round edges.The eyes are a two-colour print and need an AMS. Assembly:Glue the lid to the eyes. See the following picture for the right orientation.Then put the eyes with the lid on top of the bucket.Clip-on the handle.Push the wind-up mechanism into the bottom of the bucket. It is a slight press-fit.And now go for a walk with your bucket. Boos