Thingiverse
Wall Cabinet Pullout Tray
door Yver
114
Downloads
70
Likes
0
Makes
A simple tray to get access to the spices in the back. Attached to 8" drawer slide, but I bet a 10" would work just as good or better.
Designed to use the whole width of my print bed.
Hardware:
2 - 8" or 10" drawer slides
4 - 1/4" long screws
4 - M5x8 bolts and washer
You could glue the two pieces together, but if you crank down the bolt hard enough, its not going anywhere. I also used a 3/4" spacer when installing to avoid the hinges on my cabinet.
Designed to use the whole width of my print bed.
Hardware:
2 - 8" or 10" drawer slides
4 - 1/4" long screws
4 - M5x8 bolts and washer
You could glue the two pieces together, but if you crank down the bolt hard enough, its not going anywhere. I also used a 3/4" spacer when installing to avoid the hinges on my cabinet.
Yver publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
