Wall-E body for Mbot

A Wall-e body for mbot. Print 2x all arm parts. Will also need:
- 96 Lego tank track parts #10144
- 2x 24t Lego gear wheels (or just print from Thingiverse)
- 2x 40t Lego gear wheels (same)
- 4x Lego axle to pin connector #3749/#6562
- 1x M2x5 self tapping screw (for rear neck screw hole)
- 13x M2x10 self tapping screws
- 6x M3x10 screws
- 2x Mxx20 screws
- 4x M3x25 screws & nylock nuts (for motors)

Make sure the "starter" part is on the power switch before installing SideL. Otherwise life becomes difficult.

Enjoy!