Thingiverse
Wall for flow calibration
von Kzivi
2
Downloads
2
Likes
0
Makes
This is a simple flow calibration model for a 0.4mm nozzle.
The walls have a thickness of:
0.8mm
1.2mm
1.6mm
2.0mm
I recommend setting 100% flow first. Layer height 0.2mm.
Then measure the faces of the printout and average.
The average thickness should be 5.6mm ([0.8+1.2+1.6+2.0]/4).
So if you have a different result, substitute that into the formula for x.
y=560/x.
y is your new flow value to set in the slicer.
Repeat the printout with the new settings for verification.
The walls have a thickness of:
0.8mm
1.2mm
1.6mm
2.0mm
I recommend setting 100% flow first. Layer height 0.2mm.
Then measure the faces of the printout and average.
The average thickness should be 5.6mm ([0.8+1.2+1.6+2.0]/4).
So if you have a different result, substitute that into the formula for x.
y=560/x.
y is your new flow value to set in the slicer.
Repeat the printout with the new settings for verification.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!