Wall Grommet

Wall grommet made to fit a standard 2x4 wall. The gap between the end plates can range from 3.75 to 5.75 inches. Made to fit snugly in a standard 1.2" hole saw hole. Center hole is roughly 26mm. The only hard part about installation is getting the holes on either side of the wall to line up. You will need someone to hold one side while the other side is screwed on. TPU plug and washer were printed with 10% infill to increase flex. These are not necessary for function. The plug is made to fit around a standard CAT6 Network cable. Updated plugs to fit better in the Grommet