Thingiverse
Wall Holder For 2 Spools
by KepaP
0
Downloads
0
Likes
0
Makes
Print these two pieces and after printing for example hot glue the stopper/tip to the base piece of the build (Photo of the finished product is included on this page!)
Note:
In the included picture the product IS finished so tip is already glued.
You will have to print it in two pieces and then glue, because otherwise it would try to print on nothing.
Good luck!
Note:
In the included picture the product IS finished so tip is already glued.
You will have to print it in two pieces and then glue, because otherwise it would try to print on nothing.
Good luck!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!