Thingiverse
wall hooks tape mounted
von Tiger231
0
Downloads
0
Likes
0
Makes
this is a mount i made to hold up a small tarp over my desk because i didnt want to risk damaging the suppporting beams that are holding up the roof
it was made to work with any tape under 50mm in width
i have not weight tested this but like i said it can hold up a 4ft by 6ft tarp and seems strong
it was made to work with pla by having the print resting on the tape vs the tape sticking to the print as pla and tape dont mix well
the measurements in the photos are in mm
it was made to work with any tape under 50mm in width
i have not weight tested this but like i said it can hold up a 4ft by 6ft tarp and seems strong
it was made to work with pla by having the print resting on the tape vs the tape sticking to the print as pla and tape dont mix well
the measurements in the photos are in mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!