Wall Mount for Anetenna/Sensor Pole

Wall Mount for Weather Station Pole (25 mm) This is a sturdy wall mount designed to hold poles with an outer diameter of approximately 20–30 mm. I designed it to install the outdoor sensor of my weather station on a 2-meter-long aluminum pole (25 mm diameter). Material and Printing The mount was printed using BambuLab PETG-CF. Regular PETG should also work well. Due to weather and UV exposure, I do not recommend using other filament types unless they are explicitly rated for outdoor use. Assembly Instructions Start by inserting the lower clamp into the base. Then thread the screw into the internal thread. Once the clamp and screw are in place, gently push the clamp against the screw until it clicks into place. This allows the clamp to follow the screw in both directions. After the lower clamp is in position, insert the upper clamp (the one with the guiding tabs) and screw it in just like the lower one, don't forget the click. ⚠️ Do not pre-assemble the screw and clamp for testing purpo