Wall mount for removable stand

Because I didn't had the space to put the boat on a shelf i designed this wall mount for use with the stand.
The stand is removable so you can take it with you when going to hit the water.
Just slide in one side on the back of the mount and let the center of the stand in the higher arm of the mount.
The stand is now fixed using it's own weight and your desk is empty again.
To release, just lift the center of the stand, slide it towards you and it out.

There is a left and right version use as you like.
I've used the side with screws to the inside to make the total a bit smaller.

This wall mount is designed with shape optimization to get the most strength out of the less filament as possible.
I did not physical check the strength but is was simulated with 20N (a bit more then 2 kg at sea level) and still didn't do much at all so it should hold up for this boat + stand :)

The slide in holes where the stand is resting are in 10mm diameter so other stand sizes will fit too.