Slicer Discord
Wall Mount Lens Holder – 3D-printbaar model van MakerWorld MakerWorld
Other Hobby & DIY

Wall Mount Lens Holder

25 Downloads
14 Likes
4 Makes
Model downloaden
Wanted a study wall mount for each of my lenses. this model prints in two pieces and then is joined with two 3" wood screws. this is to ensure each section prints strong, 4 mounting holes, bottom has a hole to allow for rear lens cap cover to sit inside (canon).top section is a protection ring to protect lens from tipping/falling out. works great Top has 90mm diameter holeBottom has 60mm Diamter hole and a raised Lip with 70mm inner diamteroverall height is 87mm and width is 100mm, sticks out from wall 107mm
Categorie
Other Hobby & DIY
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Wood PLA
Min. bedgrootte
50 mm (Klein)
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

MrExo3D publiceert ook op

53 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie