MakerWorld
Organizers
Zum Modell
Wall Mount Precision Screwdriver Rack
80
Downloads
11
Likes
37
Makes
Made this one for a closet door mount application. It has deep holes to prevent the screw drivers from rattling around when I open the door. This also means the holes needed to be as small as possible, so make sure your drivers will fit. It is maxed out a little under 3.5mm shaft diameter, so scale as neccessary. I only had a couple of drivers that didn't fit and was able to bore a couple holes a little larger to make it work.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!