Wall-mounted filament guide

I needed the filament to go directly from the filament dryer, which is fixed to the wall, to the printer. Due to the filament exit angle, the filament dryer was tilted and could fall off the shelf.Now with the support directing the filament dryer output to the printer input, everything works perfectly.Next update will be to insert a PTFE tube inside the mobile tube to reduce friction. As I'm out of PTFE tubes I haven't done this yet. I used some extra fine powdered graphite to improve the lubrication inside the tube.The support that is fixed to the wall was mounted using double-sided tape and proved to be more than enough.