Thingiverse
Wall Mounted Hooks
por davidkbailey
24
Descargas
40
Likes
0
Makes
I own too many watches. Way too many when you consider the fact that I only wear one at any given time. And, many watches take up lots of space. So, I needed a place to store them.
This is a set of six all mounted hooks. I designed them for hanging watches with two-piece bands, but they could be used for hanging many other things, like keys, necklaces, or your friendship bracelet collection.
Notes:
1. The hooks are each about 5/8 inch (15mm) wide.
2. The hooks are spaced a little over 1 1/2 inches (40mm) apart.
3. The whole thing is rather long at over 9 inches (230mm), and had to be turned at a 45 degree angle to fit in my Ender 3.
4. There are three countersunk holes for mounting, but I just used 3M Command Strips.
This is a set of six all mounted hooks. I designed them for hanging watches with two-piece bands, but they could be used for hanging many other things, like keys, necklaces, or your friendship bracelet collection.
Notes:
1. The hooks are each about 5/8 inch (15mm) wide.
2. The hooks are spaced a little over 1 1/2 inches (40mm) apart.
3. The whole thing is rather long at over 9 inches (230mm), and had to be turned at a 45 degree angle to fit in my Ender 3.
4. There are three countersunk holes for mounting, but I just used 3M Command Strips.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!