MakerWorld
Other Art Models
Model downloaden
Wall-mounted Pool Cue Holder
108
Downloads
54
Likes
33
Makes
Designed to hold 4 cues (of reasonably similar length :) ). Each half of the mount attaches with two #6 fasteners (holes are pretty generously toleranced, so should be easily cleaned out up to a #8... I think). I have printed both sides in both resin and filament and both turned out just dandy. Because I did not alter any of the surfaces produced by the GD solver, the upper, in particular, is a bit unfortunate from a support material need perspective. But, I was able to print and clean up two of them without too much hassle. I really like the way these organic structures look in resin, so that's what I ultimately went with on my wall :)**"Lessons learned"**One significant(ish) revision I think I'll probably have to make in the future is to modify the Upper to have larger openings...shouldn't need to be a sharp shooter to put the cue AWAY I suppose. It works fine as is, and I'm planning to use mine until it won't let me anymore, but I can see one....libated?...guest missing with confide
BubsBuilds publiceert ook op
217 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!