MakerWorld
Other House Models
Zum Modell
Wall Mounted Toothbrush Holder
111
Downloads
18
Likes
55
Makes
I needed something to hold my toothbrush on the wall while keeping the bristles far from anything. So i created this wall-mounted holder that only requires one screw and <2 hours of printing. All you need is the 8 - 1-¼" screw with the proper anchor. Some support is required but its not too much of a hassle. There is a drain hole at the bottom so the water can freely flow out and so there is a low chance of mold appearing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
