Thingiverse
Wall Mounted Umbrella Hook
von FriskyTater
90
Downloads
92
Likes
1
Makes
Umbrella shaped wall hook to hang your umbrella from!
No supports needed if printed in default orientation.
The 'canopy' of the umbrella prints face-down, and can benefit from a textured build plate.
Screw holes for either M3 or M4 (#5 - #8 for Imperial), depending on how heavy your umbrella is you can use one or both.
Only had gray PLA on hand, but would look pretty sharp in different colors!
No supports needed if printed in default orientation.
The 'canopy' of the umbrella prints face-down, and can benefit from a textured build plate.
Screw holes for either M3 or M4 (#5 - #8 for Imperial), depending on how heavy your umbrella is you can use one or both.
Only had gray PLA on hand, but would look pretty sharp in different colors!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
