Thingiverse
Wall Mounting Tray
por do9m
0
Descargas
0
Likes
0
Makes
I created this to put next to my wall painted as a chalk board, to hold chalk. Could be used for any number of smallish items.
-Printed on TRONXY X5SA
-no support needed
-.2 or .3 would work for layer height
-printed in white Geeetech PLA
Note: I did have to use my Dremel to sand the inside of the screw slots/holes to fit the screw I was going to use...my printer has bad precision.
-Printed on TRONXY X5SA
-no support needed
-.2 or .3 would work for layer height
-printed in white Geeetech PLA
Note: I did have to use my Dremel to sand the inside of the screw slots/holes to fit the screw I was going to use...my printer has bad precision.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
