Thingiverse
Wall Support Plate
von peterp53
3
Downloads
2
Likes
0
Makes
About the wall plate:
This was designed because the bathroom fitting kept on falling off the wall. This was because their was no noggin or stud to drill into therefore only 10mm plaster. It is designed to spread the load over a wider area hence giving more support for the fitting.
Size:
The base plate is 100mm in diameter and 10mm in height.
After printing:
The base plate cover is glued on to hide the screws.
This was designed because the bathroom fitting kept on falling off the wall. This was because their was no noggin or stud to drill into therefore only 10mm plaster. It is designed to spread the load over a wider area hence giving more support for the fitting.
Size:
The base plate is 100mm in diameter and 10mm in height.
After printing:
The base plate cover is glued on to hide the screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
