Wall Thickness Test

I made this as a way to test the transparancy of different filament. The boxes and rings are made large so that you can use a flashlight to shine in the middle and see how much light shows through.

This will test 0.2mm, 0.4mm, and 0.8mm wall thicknesses.

Also tests to see how clean your printer can make straight and curved walls. You can't use Vase Mode to do this, as the towers are not connected.


For those of you with a 0.4mm nozzle, "Extrusion width" should be "0.39mm". That will get both 0.4mm and 0.8mm sets to show properly.

For those of you with a 0.2mm nozzle, "Extrusion width" should be "0.19mm". That will get 0.2mm, 0.4mm and 0.8mm sets to show properly.

===============================================================

If you'd like to support my work, or buy me a Monster (I don't drink alcohol or beer), you can head over to my Patreon Page:
www.patreon.com/m1dn1ghtn1nj4

A portion of EVERY months earnings goes to a charity chosen at the end of the mont