Thingiverse
Wallmount for Echo Dot Gen. 3
von sharkymoto
30
Downloads
31
Likes
0
Makes
**Wallmount for Echo Dot Gen 3**
Print upright with no support. Objective was to have enough surface to use 3M VHB Tape to mount the Dot behind my TV. Added screwholes just in case someone wants to wallmount it using screws.
The Echo is held very secure since i based the Model on a real CAD model of the device, so it fits really snug and is not going to fall out even if moved.
**Help me out**
Using the affiliate Link gives me a small kickback and doesn't cost you anything, so if you need filament anyways, using the link below would be very kind!
Mounting Tape: https://amzn.to/36TwTaN
Green PLA: https://amzn.to/34NMfgX
Black PLA: https://amzn.to/34PxlqE
Yellow PLA: https://amzn.to/34PJYSy
Print upright with no support. Objective was to have enough surface to use 3M VHB Tape to mount the Dot behind my TV. Added screwholes just in case someone wants to wallmount it using screws.
The Echo is held very secure since i based the Model on a real CAD model of the device, so it fits really snug and is not going to fall out even if moved.
**Help me out**
Using the affiliate Link gives me a small kickback and doesn't cost you anything, so if you need filament anyways, using the link below would be very kind!
Mounting Tape: https://amzn.to/36TwTaN
Green PLA: https://amzn.to/34NMfgX
Black PLA: https://amzn.to/34PxlqE
Yellow PLA: https://amzn.to/34PJYSy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
