Thingiverse
Wallmounted Spolholder
door dbauer
1
Downloads
2
Likes
0
Makes
This is my wall mounted Spool holder.
It fits 1 used and 6 inactive spools of filament through the help of a 15cm long 8mm thick threaded rod.
The are mounted the following: nut, washer, wood, washer, nut.
To hold the used spool i use two ordinary wooden corners, which are simlpy screwed onto the board. The board dimensions are 40cm x 100cm. On top of the i glued the two rodmounts. The spool hangs on a 7mm Ø alubrass rod, The rod is glued into to grip with two component epoxy glue.
The exactly measurements you can find in the attached schematic.
It fits 1 used and 6 inactive spools of filament through the help of a 15cm long 8mm thick threaded rod.
The are mounted the following: nut, washer, wood, washer, nut.
To hold the used spool i use two ordinary wooden corners, which are simlpy screwed onto the board. The board dimensions are 40cm x 100cm. On top of the i glued the two rodmounts. The spool hangs on a 7mm Ø alubrass rod, The rod is glued into to grip with two component epoxy glue.
The exactly measurements you can find in the attached schematic.
dbauer publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
