Wand Extractor Glide

I made this about a year ago for Carpet Wands as a glide.My intention was to make this into nylon but it bent my assembly on a run, took me a few months to get it back in fighting shape. Anyways, I had a few people who wanted me to share this and so here it is! It's made to snap together and I formed it to the Mytee Jet Ez 10 inch.If you make this for larger wands, I recommend just making them taller at first, this print doesn't use much filament and take long.Will post the full body one in case you need to make it deeper as well (it gets finicky). I found that this cost a dollar at 25% in pla.I recommend doing it PLA for shaping and then graduating into ASA or ABS.I found that extractors lose a lot of heat in the water by the time it needs to extract that even PLA wasn't bad until you got to 4 jet truck mount, then ASA/ABS made sense (nylon does well but that sob is rough to print).After you snap it together the first time successfully, look for gaps.Egregious, then change