Wanhao-Cocoon-Monoselect LED bracket

Put a rear fan on the printer and couldnt stand the bracket on the front with nothing on it. Made this up for a dual LED 5050 strip. Can use a single row if needed. If you're running this on a 24VDC like I am you will need to put a 240ohm (1W) resistor in series or 2x120ohm (0.5W) in series. I just ran it off the extruder fan port so it comes on when the printers on. Will need 2x M3x5mm screws to hold it on. They should screw straight into the bracket without nuts. If the colour block in the back is a bit loose you can use M3x6mm screws and they will hold it in tight.