Thingiverse
Wanhao D4S Cable Bracket
von AngryHuntr
1
Downloads
0
Likes
0
Makes
I made this bracket to stop the cables from chaffing on the print head center screw after i experienced some electrical issues.
I cut the white plastic spacer down slightly so I could reuse the existing hardware
I cut the white plastic spacer down slightly so I could reuse the existing hardware
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
