Wanhao Duplicator i3 Mini Bed Level Test

Updated:

I recommend printing with a skirt in Cura at 0.1 mm layer height. There are 3 versions of the test.

Version 1 should print as a single layer. It is similar to other level tests out there.

Version 2 prints as two layers.
- I found that sometimes layer one looked good, but layer two showed signs of the nozzle being too high. I felt that v2 helped me fine tune settings. Your mileage may vary.

Version 3 prints as a single layer.
- Will take longer to print because it includes some additional test points on the bed.

I'd love to know if this ends up helping any of you WDi3M (or clone) owners.