Wanhao i3 Cable management

Credit Goes to imagineering4 (http://www.thingiverse.com/thing:1261720) for rear cable conduit.

I just incorporate my designed bed harness to reduce wire strain on Y-Axis cables and tidy up the wirings. I use two M3 bolt and nuts to lock the harness and inside a case there's a holes for cable tie to secure the wires. For the wire management, I use a plastic split loom tubing to hold the cables.

Please note: for the bed harness holder, I designed it to fit on my current setup, considering the placement of wire and solder. The soldering points act as a stopper for the wire harness with the help for 2 M3 bolts to securely clip it on the print bed. You may need to measure actual setup on your printer and made some adjustments.

Lastly this is still work on progress since I'm still working to modify the rear cable conduit to move the wires at the center.

If you like the thing please share with us.