Wanhao i3 E3D V6 Volcano mount

Here is my mount for an E3D V6 on a Wanhao i3.
The hot end nozzle is in the same place as the original (apart from being a couple of mm forward on the Y axis), so no need to adjust the end stops.
The cover for the filament gearing increases the rigidity, but this means there is no space for the original plate mounting the X end stop and cable mount, so these have been incorporated into the mount.
The original bolts for the X end stop, cable mount and belt are all reused. For those with a tap set, the cable mount thread is M3x0.5 and the belt thread is M4x0.7, else a file and some heat should help cut the threads.

This also requires:
2 of M3 x 30mm bolts + nuts for the clamp
2 of M3 x 23mm bolts (cut down longer bolts) for the filament motor.