Thingiverse
Wanhao i3 Mini PushButton repair
door Jpeg13
8
Downloads
3
Likes
0
Makes
Hi,
i just LOVE my Wanhao Duplicator i3 Mini...
Think i printed several KILOMETERS of PLA during the last year :-)
Of cause, that means some wear...
What i hated most, was the PushButton...
Had to press it very HARD to get any result, and that got worse daily...
I know, it´s no Rocket Science, but that little shim i post here should do the trick :-)
Just pull off the PushButton, insert the shim, (a 5mm drill will be helpful) and put it on again.
Happy Printing !
i just LOVE my Wanhao Duplicator i3 Mini...
Think i printed several KILOMETERS of PLA during the last year :-)
Of cause, that means some wear...
What i hated most, was the PushButton...
Had to press it very HARD to get any result, and that got worse daily...
I know, it´s no Rocket Science, but that little shim i post here should do the trick :-)
Just pull off the PushButton, insert the shim, (a 5mm drill will be helpful) and put it on again.
Happy Printing !
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!