Wanhao I3 Plus / MP BLTouch Bracket

BLTouch Bracket for The Wanhao Duplicator I3 Plus / Monoprice Maker Select Plus.

Your going to want to move the spacers under the screws holding down the board, to underneath the board. Need to raise the height a little to clear the screws that came with the BLTouch.

I Made this bracket because the bracket provided by Sebastion for ADVI3++ did not work with my setup.

You can still use this bracket and his wiring / instructions for the BL-Touch. just make sure to correct your Z-Offset.

For this bracket, if the BL-Touch Screws are bottomed out, the Offset is ~"-2.1"

Although this offset works for me, yours may differ slightly! After getting your firmware updated and installed, Use the Command "M851" to see your current Z offset.
Ideally your nozzle should touch the bed at Z0.

You may need to print a test layer to determine if your nozzle is too high/low

IF the nozzle is too high, then decrease your offset closer to 0. eg. -1.8

Too low, increase in the negativ