Thingiverse
Wanhao i3 Re-Duplicator Auto-leveling BFPTouch Sensor
von HeSlamsAJet
8
Downloads
10
Likes
0
Makes
Re-mixed design from [brunofporto's BFPTouch original design](https://www.thingiverse.com/thing:2890290). The original was too long to fit into the small space from the [ReDuplicator i3 MK3x's](https://www.thingiverse.com/thing:2686588) front extruder plate to the bed (24-28mm clearance). This one should fit.
Edit: the extruder motor has been getting up to 90C and has been deforming the mount point for this. I printed out the extruder plate in ABS and gave it a coat of epoxy and it seems to be holding up just fine. Also ordered some high-heat deflection material... we'll see.
[Fusion 360 public link for this re-design](https://a360.co/2UVC2st) - link allows you to see the construction. Use the exploded view.
Edit: the extruder motor has been getting up to 90C and has been deforming the mount point for this. I printed out the extruder plate in ABS and gave it a coat of epoxy and it seems to be holding up just fine. Also ordered some high-heat deflection material... we'll see.
[Fusion 360 public link for this re-design](https://a360.co/2UVC2st) - link allows you to see the construction. Use the exploded view.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!