Thingiverse
Wargaming Blast Template
door Zarquon
38
Downloads
19
Likes
0
Makes
This is my blast template for tabletop gaming. My plan is to use this with my all printed army in warmachine. The rings are at 3, 4 and 5 inches. The cutouts start at the actual distance (e.g. the inner disk is 3in and then the cutout occurs). The underside in the print has scatter markings for rolling a d6.
My test print was not going to come out well due to bed leveling problems over the large size of this. I canceled that print and have not had a chance to try again. If your print bed is sufficiently level it should print fine though.
I’ve also included a simple 3 inch template separately since I plan to need several of the 3in size concurrently.
Update 1/18/12
I added a 4in and 5in simple marker to.
My test print was not going to come out well due to bed leveling problems over the large size of this. I canceled that print and have not had a chance to try again. If your print bed is sufficiently level it should print fine though.
I’ve also included a simple 3 inch template separately since I plan to need several of the 3in size concurrently.
Update 1/18/12
I added a 4in and 5in simple marker to.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
